Behringer DCX2496 Ultradrive Pro

I've been running a bunch of these, both in rental and installation usage and these run great. They are able take tremendous amounts of abuse and still beat up the big boys. Spill a drink on a device that costs more than four times what this little beast does and your night is ruined. Do that on a DCX and it still runs fine, of course buttons will be a bit sticky but that's all. Outdoor events are no problem, and it performs as well on a sunny beach as during the coldest Finnish winter nights.


It's a bit shame that this device doesn't have a modern interface connection and only comes with a outdated RS-232 serial port. However, the UI is great and every option is configurable from the front panel only. There are some caveats what comes to channel naming and initial setup (especially this is extremely misleading - DCX's routings are not limited to what initial setup offers), but once one does that a couple of times the rest is simple. DCX's UI easily beats up in usability some of the higher end gear that are either software-only configurable or front panel driven.


One of the most useful feature is dynamic EQ. It may sound a bit ankward at first, but for fixed installations it's terribly useful for compensating eg. lack of bass when the night is still young and sound levels are quote low. As it may be applied as well for outputs as inputs, it doesn't eat up all DSP resources. DCX doesn't have unlimited resources, but they'll grant EQs in all inputs, steep HP/LP and limiters in all outputs. The percentage of remaining DSP resources is readily shown, which is not always the case with these kind of devices regardless the make.


Of course, the DCX and it's cheap price only gets it so far. Connectors are pretty poor, feel flimsy and are no match for brand names. Also, the third input channel is pretty useless as only two channels may be summed together. Neither input nor output sensitivity is selectable, but usually it's something that one can live with. In a prolonged installation usage internal power supply will eventually fail after a few years as the input caps dry. When that happens, usually most of the input and output channels are also destroyed thus rendering the device beyond any economical repair. Diyers take note.


While DCX gradually fades in obscurity at this pace (due to lack of modern interfaces or any real hardware upgrades within the past 10 years), it still offers a great bunch of features for a fraction of price what more modern devices cost. Unless more input channels (consider this as a two channel device) or a network connectivity is required, I'd still buy DCX and a spare unit to go along as nothing is eternal.

The Behringer DCX2496 Ultradrive is a great device, and does more than most other units.
The price is great, but dont let the cheap price put you off. This unit has more functions that some DBX units and its a 3rd of the price. It will take some time to digest every single function, but once you have had a browse through the unit is a dream to use and is very flexible.
We have used several of these on installs and they are simple to setup. You can also set a pin code so that you can effectively "lock" the unit to prevent DJ`s and the like messing around with the unit.
Great item at a great price. Behringer do it again!

Amazingly versatile crossover / equaliser / delay etc.

I used one of these to provide separate equalisation to two different pairs of speakers, time delay to the rear pair with separate Low Pass filter to central woofer (i.e. 2 ins, 5 outs). Also provides volume limiting (as this was an installed system which we did not want turned up too loud - spoil sports!).

It takes a while to get the hang of setting up it from the front panel - bit of a learning curve, and parametric equalisation needs a lot more thought than graphic. Only small gripe is that the bar graphs are relative to about +20 dBu (i.e. peak at full input) so will tend to be on the bottom few segments with normal mixer output levels.

I bought the DCX2496 to replace simply an equalizer.

I use this along with EV Zx3-90B Speakers and QSC-GX7 Amp.

the sound quality is impressive, what is most impressive is if you have DJ'd at a venue before and saved presets, it is possible to load them again with just a few clicks.

I have been using the free software that comes with the DCX2496, from there I am able to control everything with ease.

for me I am running 2 speakers, 2 subs and 2 monitors connected to the DCX2496, I have configured the equalizer, mid-pass and roll-off adjustments for my gigs, as well as the limiter, my favourite feature is the assignments from source to any output and all of the above is configurable at source or at each output individually and it works great!

there is also the ability for dynamic eq, and compression, however as there is so much you can do with the DCX2496 I just have not got around to doing this.

but overall a great product from Behringer, and I would say this is a much cheaper alternative than to buying products such as from DBX where for pretty much the same features you could be paying up to three times as much all-be-it there is most likely some differences in quality and finish.

For something with such a great value, this unit has proved to be reliable, versatile and much worth the purchase price. I bought one of these units in order to properly manage my small PA system (2 ZLX12P'S and 1 ETX18SP.

I am now able to use my ZLX12P's for bigger crowds now I can EQ them, It gave me the ability to set a high pass filter on the ETX18SP at 40hz in order to save the driver.

I have not yet had any issues but I do wish that it used different connectors to connect the unit to its software however it is very usable just by using the unit display. As the parametric EQ is difficult to use at first, you will get used to it after an hour or so (If new to system EQ's) and it has proven to be a tremendously useful asset to my system.

Great buy, one of the only Behringer products I can truly support.